z The ATD auto-darkening welding helmet comes assembled but before it can be used it
must be adjusted to fit the user properly and set up for response time, sensitivity and shade
level.
ADJUSTING THE FIT OF THE HELMET
z The overall circumference of the headband can be made larger or smaller by rotating the
knob on the back of the headband. (See adjustment “Y” in fig.1)
This can be done while wearing the helmet to allow just the right tension to be set to keep
the helmet firmly on the head without it being too tight.
z If the headband is riding too high or too low on your head adjust the strap that passes over
the top of your head. To do this, release the end of the band by pushing the locking tab out
of the hole in the band. Slide the two portions of the band to a greater or lesser width as
required and push the locking tab through the nearest hole (See adjustment “W” in fig.1)
z Test the fit of the headband by lifting up and closing down the helmet a few times while
wearing it. If the headband moves while tilting, re-adjust it until it is stable.
z ADJUSTING DISTANCE BETWEEN HELMET & FACE
Step 1:
Loosen the block nut (See "T" in fig.1) to adjust the distance between the helmet and
your face with the helmet in the down position.
Step 2:
Loosen the block nut on either side of the helmet and slide it nearer to or further from
your face. (See adjustment "Z" in fig.1) It is important that your eyes are each the same
distance from the lens otherwise the darkening effect may appear uneven.
Step 3:
Re-tighten the block nut when adjustment is complete.
INSTRUCTIONS FOR USE
WARNING! Before using this helmet for welding ensure you have read and
understand the safety instructions
