Atlona Technologies AT-HD4-V42 Manual

next previous

Toll free: 1-877-536-3976

Local: 1-408-962-0515

1. Place your switcher within 60 feet (18.29 meters) of your displays.

Note: If using the supplied IR remote control, remember you need to be within 23 feet (7

meters) and within a 60° angle of the infrared receiver.

2. Connect the HDMI cables to your sources and the switcher’s inputs labeled HDMI IN.

Note: The Ethernet Channel will not pass to your devices if the HEC feature is not

supported or you are not using the correct HDMI cables.

3. (Optional) Plug the supplied Infrared module into the IR IN port and place the receiver

end somewhere that is within 23 feet (7 meters) of where you will be using remote.

Note: The supplied infrared module will allow you to control the Atlona AT-HD4-V42

when placed in a cabinet.

4. Plug the power cord into the DC 5V labeled port and then plug the other end into the

wall.

5. (Optional) Plug the Ethernet cables into the Ethernet ports. If your devices and cables

are HDMI Ethernet Channel compatible you will be able to pass the internet signal

through the HDMI cables.

Note: Please verify that your devices are HDMI Ethernet Channel compatible, most ports

willbelabeledHECforeasyidentication.

6.(Optional)PlugtheDigital(S/PDIF)cableintotheS/PDIFport.Ifyouhaveanaudio

system this will allow for 2 channel and multi-channel support.

Note:IftheDigitalAudioispluggedinitwilltakerstpriorityovertheHDMIaudio

connection. Neither Dolby TrueHD or DTS-HD Master Audio will work with this option.

a. (Optional) ARC Mode – The Audio Return Channel can be accessed through

the switcher, by reselecting the source you currently have selected (all source

lights will go off). The switcher will then pass through the audio from your video

 displaytoyourA/VReceiverasanARCsignal(thiswillonlyworkwithARC

capable displays). Your video display will pass through audio from either

its internal tuner or from any device plugged into it.

7. Connect the ends of the HDMI cables into the video displays and the other ends into

the ports labeled HDMI OUT on the switcher.

8. Press the power button (on either the remote or the switcher) to turn on the

AT-HD4-V42.

9. (Optional) If using the RS-232 connection, plug the cable into the switcher, then your

computer or third party control.

Note:YoucanpurchasetheRS-232cableat:http://www.atlona.com/

a. PC control will need a hyperterminal program. If you do not have one

then you will need to download or purchase one and follow their

instructions for the program’s installation.

Step by Step Guide

atlona.com

AT-HD4-V42

Atlona HDMI 4 by 2 Switcher