128-7410
4 of 20
Page 4
To exit program mode, turn ignition off, or press and release valet switch.
RF Programmable Features Bank 3 Is Remote Start Selectable Features:
To program these selectable features;
Turn ignition on No response
Press and release the program switch 3 times 1 flash
Within 3 seconds, turn ignition Off Then On, Off then On
This Action Accesses Feature Bank 3 Remote Start Selectable Features
Press transmitter lock button to change
or
Press and release the program switch
Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps 6 Chirps
1st Defrost Output Not Available
2nd RF Start Chirp Not Available
3rd Run Time 5 Mins 10 Mins 15 Mins 20 Mins
4th Parking Lights On Steady Flashing
5th Input Check Voltage Tach
6th Voltage Level >0.5V B4 Start < 0.5V B4 Start
7th Ing. 2 Select Off During Crank On During Crank Same As Accy.
8th Ign. 3 Select Off During Crank On During Crank Same As Accy
9th Diagnostics Off On
10th Crank Time 0.8 Sec 1.0 Sec 1.5 Sec 2.0 Sec
11th Gas/Diesel Gas Diesel 10 Diesel 15 Diesel 20
12th Transponder O/P While R/S On During Start Until Ign. Off
13th Temp Start Not Available
14th Crank Averaging Averaging Preset Time Note: When averaging, the engine must be started
4 times with the key to be effective.
15th R/S Shock Not Available
16th Turbo Select Off 3 Mins 5 Mins 10 Mins
17th Black/Blue (Aux O/P) Single Pulse As Bnk 2 Feat #1
When using the RF programmer, enter the program mode as follows:
Turn the ignition on
Press and release valet/program switch 3 times
turn ignition off then on
Press and hold valet/program switch for 5 seconds
Siren chirps 2 times indicating access to RF feature program mode
To exit program mode, turn ignition off, or press and release valet switch.
