![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/3/aa/3aa86692-9266-4786-a105-d64361f30b92/3aa86692-9266-4786-a105-d64361f30b92-bg9.png)
1) Make the connections to the vehicle for the 12 pin wiring harness.
2) Connect power harness to vehicles electrical system by tapping into an accessory
hot line and a good ground.
3) Connect the 12 pin harness to the mating connector on the video monitor.
4) Verify all functions of the system before final mounting of the finished assembly.
A/V Source Definitions:
1. PS2 - Built in song PS2
2. AV1
- Supplied 12 Pin Power / Signal Harness to 3 RCA Jack Pigtail is used for
AV1 input.
3. AUX - AUX input.
*NOTE: If the optional relay box is P/N SIRSWB installed, it recommended that the
antenna for the FM modulator antenna wire is unplugged. See VOD10PS2
Wiring Diagram (Figure A) for antenna location.
**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the
FM modulator to exceed FCC limits of wireless transmission. When installing
the unit position the antenna for best reception.
WIRING DIAGRAM
9
Figure A
* Antenna for Wireless FM Mod.
** See Antenna Note
12 Pin Power /
Signal harness
Line Out-R (Red)
Line Out-L (White)
Line Out-V (Yellow)
Dome Light
Power source
Auxiliary Video Display
2 Pin Power
Wire Harness
with choke
Line Out-R (Red)
Line Out-L (White)
Line Out-V (Yellow)
AV1 Video
Source
* Optional Relay Box
SIRSWB