--:-
<PDU_ID>
cli->
[cycle|on|off]<outlet number>,<outlet number>To power control (on, off, cycle, lock, unlock) outlets of one specific PDU under the
power management level:
1. Go to the outlet level for the specific PDU.
--:- / cli-> cd power_management/pdus/<PDU_ID>/outlets
2. Launch the power command with a specific outlet number, range of outlets (use a hyphen
to specify the range) or list of outlets (number or name separated by a comma).
--:- outlets cli-> [cycle|on|off] [<outlet number>]
-or-
--:- outlets cli-> [cycle|on|off] <outlet number>-<outlet number]
-or-
--:- outlets cli-> [cycle|on|off] <outlet number>,<outlet number>
passwd
Configure the password for the current user. The terminal does not echo the password.
Syntax:
--:- / cli-> passwd
opiepasswd
Configure a one time password (OTP) for the local user. After you type the command, you will
be asked for the pass phrase to use for the OTP.
NOTE: Use thiscommand to restart the sequence number.
Syntax:
--:- / cli-> opiepasswd -f -c <username>
Example:
opiepasswd -f -c teste
Adding teste:
Only use this method from the console; NEVER from remote. If you are
using telnet, xterm, or a dial-in, type ^C now or exit with no password.
Then run opiepasswd without the -c parameter.
Using MD5 to compute responses.
Enter new secret pass phrase:
Again new secret pass phrase:
ID teste OTP key is 499 AC0241
FOOD HUGH SKI ALMA LURK BRAD
16 Cyclades™ ACS6000 Advanced Console Server Command Reference Guide
