Anchoring Instructions
Phase 1
Phase Notes
• Assemble with hardware as shown.
• Install the screw into the upright so that the
tip of the screw does not stick through. Make
sure you have enough wood to accommodate
the screw before installing.
• FAILURE TO USE STAKES CAN VOID
WARRANTY & CAUSE INJURY!
Stake
Stake
Stake
Stake
Stake
Stake
Parts needed:
• (6) KD - PLASTIC GROUND STAKE BROWN - A100179
• (2) FB - SWING SEAT ASSEMBLY - A100170
• (1) KF - PLASTIC TRAPEZE BAR ASSEMBLY YELLOW - A100109
Hardware needed:
• (6) BV - SCREW PFH 8x2-1/4 - H100091
BV
Step 1:
Drive Stakes 'KD' into the
ground against boards where shown
and attach with Screws 'BV', as
shown.
Step 2: Attach Swing Seat Assembly
'FB' to swing beam.
Step 3: Attach Trapeze Bar Assembly
'KF' to swing beam using
pre-assembled quick clips installed on
the swing beam.
Final Step:
Double check and make sure
every bolt, screw and nut is tight. Make
sure every board is secure. Make sure
the fort is level and enjoy your swing set.
Trapeze
Bar
Swing
KD
