Display Controller 11
Installation Procedure
The following instructions will take you step by step through the
installation of the Barco display controller(s) for your Barco Display
System.
1 If you are not going to use your old graphics card, uninstall the
drivers and software for it if you have not already done so.
2 Turn off the computer, display(s), and other peripheral devices.
3 Unplug the computer’s power cord and disconnect all cables from
the back of your computer.
4 Remove the computer cover.
If necessary, consult your computer’s manual for help in removing
the cover.
5 If necessary, unscrew or unfasten and remove any existing
graphics card(s) from your computer.
6 Locate the appropriate slot and, if necessary, remove the metal
back-plate cover(s).
Wear a grounded, protective ESD strap when handling or
during installation of the display controller. Electrostatic
charges can damage the display controller.
Wait approximately 20 seconds after unplugging the
power cord before disconnecting a peripheral or
removing a component from the motherboard to avoid
possible damage to the motherboard.
WARNING
If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a
multiple-display setup, disable it either in the computer’s
System Set-up utility (BIOS) or the Windows device
manager.
