17
Programmer / Clock
The clock on this product has two
modes of operation, fully automatic or
semi-automatic. This product is
intended for use on the semi automatic
mode only. If for some reason this
mode has not already been pre-set,
the following procedure should be
used to set it to this mode:-
1. Turn the power off to the appliance
for 30 seconds or more , then turn the
power on.
2. Within the first 6 seconds of turning
the power on, press the plus
button for 1 second.
3. The operating mode “P2” can then
be selected using the plus or minus
buttons.
4. The clock has now been set to semi-
automatic mode, any power fail
situations will not change the selected
mode.
