A SERVICE OF

logo

SERVSWITCH™ MULTI
106
9.2.4 THE COMMAND-LINE-ENTRY WINDOW
You can access the Command-Line-Entry Window (shown in Figure 9-3) by pressing the [Ctrl] key twice, then
pressing [Alt] + [Tab] twice. (System administrators will have to press [Alt] + [Tab] three times, because they
have to bypass the User-List Menu—see Section 9.2.2.) You can also access this window by pressing the <CM>
Command Mode hotkey sequence (see Sections 8.2.1 and 8.12); in fact, whenever the Command-Mode
sequence is pressed on a computer attached to a UICD, this window pops up.
Figure 9-3. The Command-Line-Entry Window.
This window features a field where you can enter any ServSwitch Multi keyboard command; just type in your
command (without preceding it with another Command-Mode sequence) and press [Enter]. Refer to
Section 8.2 and Sections 8.6 through 8.15 for information about all available commands.
Command Line
Enter your command above
Program Manager