25
CHAPTER 4: Startup/Configuration
Figure 4-5. Network Parameters menu (system mode only).
The following options are available:
1. IP Address: Defines the IP address for the Dual-Port Network Power Switch.
Type 1, press [Enter], and follow the instructions in the submenu. (Default =
undefined.)
2. Subnet Mask: Defines the subnet mask for the Dual-Port Network Power
Switch. Type 2, press [Enter], and follow the instructions in the submenu.
(Default = undefined.)
3. Gateway Address: Defines the gateway address for the Dual-Port Network
Power Switch. Type 3, press [Enter], and follow the instructions in the
submenu. (Default = undefined.)
4. IP Security: Sets up the IP Security feature as described below.
5. Mac Address: Displays the unit’s Mac address. Note that this item is not used
to redefine the Mac address.
I
MPLEMENTING
IP S
ECURITY
The Dual-Port Network Power Switch can be configured to restrict unauthorized IP
addresses from telneting to the unit. This allows you to grant Telnet access to only
a specific group of IP addresses, or block a particular IP address from gaining
access. In the default state, the Dual-Port Network Power Switch accepts incoming
IP connections from all hosts.
NETWORK PARAMETERS:
1. IP Address: (undefined)
2. Subnet Mask: (undefined)
3. Gateway Address: (undefined)
4. IP Security
MAC Address: 00-40-05-5e-f3-90
Enter Selection or <ESC> to Exit…
