Divar 700 Series Advanced configuration | en 69
Bosch Security Systems Installation and Operation manual F.01U.246.471 | v3.6 | 2011.11
Control tab
– Enable PTZ when a controllable camera is connected. By default, PTZ is disabled.
– Select protocol and device address on PTZ bus. (PTZ commands are transmitted across
the RS485 and Biphase bus simultaneously. Each camera should have a unique address
greater than 0.)
6.2.2 IP Channels
A General tab and a Control tab are available for each camera.
Note:
An IP stream must only be connected to a single channel on a single Divar. There should be no
connection to any other device that could influence the settings of the IP device.
Figure 6.5 Configuration menu - Video & Audio - IP camera
IP camera
If an IP connection has already been configured, the IP address, input type, and stream
number is displayed. If a connection has already been established, a video preview appears.
Note:
The Divar will overrule the encoder profile set in the camera itself if required by the following
settings.
