WZ16 Integrated IR Bullet Camera Conguration | en 13
4 Conguration
Follow the steps below to adjust the zoom and focus. Remove the lens cap before
making adjustments, then replace it when you nish. Refer to the gure below.
Figure 4.1 Lens adjustment
Number Description
1 Zoom control
2 Focus control
3 Video brightness
CAUTION!
To prevent humidity problems, the camera must be installed in dry conditions.
Removing the lens cap in a wet or humid environment may result in condensation on
the front window.
4.1 Adjusting the Zoom
1. Loosen the Zoom lock screw by turning it counterclockwise.
2. Adjust the zoom by moving the Zoom lever to Tele side or Wide side.
3. Turn the Zoom lock screw clockwise to tighten the focus lever after adjustment.
4.2 Adjusting the Focus
1. Loosen the focus lock screw by turning it counterclockwise.
2. Adjust the focus by moving the focus lever to near side or far side.
3. Turn the focus lock screw clockwise to tighten the focus lever after adjustment.
4.3 Adjusting the Video Output Brightness
1. Adjust the brightness from VR according to the environment.
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2010.12
