Page 42
SEAT REMOVAL AND INSTALLATION
Front Seat Installation
Instructions
1. Roll seat base into position, just
behind the floor mounted strikers.
See Figures A and B. Move seat
base forward to engage front
strikers. See Figures C and D.
Note: Position outside of seat
base alongside wall panel for
easy alignment.
2. Depress rear cross bar (push
down) to stow rear wheels and
engage rear seat attachments
with floor strikers. See Figures
C-F. Lift seat to ensure floor
strikers are locked in seat at-
tachments.
3. Connect (plug) seat electrical
harness to B-pillar receptacle.
See page 37.
Seat attachments
must be fully latched
in floor supports be-
fore occupying seats
or operating vehicle.
Failure to do so will
result in serious
bodily injury.
Front Seat Bases
“Step & roll” quick-release seat
base attachments engage re-
cessed floor strikers (supports). A
foot-activated release pedal is lo-
cated at the rear of the seat base.
A cross bar is positioned directly
under the pedal. Stepping on the
bar engages the rear seat base at-
tachments to lock the seat base.
Engagement
Bar
