5
OUT OF RANGE
OUT OF RANGE
• Full DOT approved lighting package with reflective tape
• Front tongue jack, rated for 7,000 lb capacity.
• Target trailer weight 5,500 lb.
• Trailer width of 8' ft.
• Spare tire included.
• Maximum tongue weight 500 lb.
D. HYDRAULIC SPECIFICATIONS
• 16 HP gasoline engine set at 3000 RPM (16 HP diesel engine is an option).
• 8.4 cc or 0.51 cu. in. Sunstrand pump is used to generate up to 6.5 GPM fo
hydraulic fluid.
• System pressure is set at 2500 psi on the apitech valve.
• 12 Gallon fuel tank estimated to last up to 12 hours of operation.
• Hydraulic oil sight gauge is mounted on hydraulic tank to monitor oil level.
• A 5 micron high pressure and 10 micron low filter are used to keep the
hydraulic oil clean. Both filters will indicate on the ECB when elements
are plug.
• Apitech valve controlled (ECB controlled) hydraulic ME-24 Ross motor to
drive arms. Motor to have pulse sensor (30 pulses per rev).
• Apitech valve controlled (ECB controlled) 56 inches hydraulic cylinder to
move drum. Drum to have potentiometer mounted to provide signal feedback
on drum location.
• 2500 psi, 6.5 gpm external hydraulic circuit, controlled by Apitech valve
(ECB controlled). Plumbed at rear of trailer with quick connects for
Condux FO Blower.
• Thermostatic control valve is used on the inlet of the cooler to prevent
hydraulic fluid flowing through 7.8 HP cooler when the temperature has yet
to reach 100 C.
E. ELECTRONIC CONTROL SYSTEM SPECIFICATIONS
Contained within a separate set of documents:
• Remote Electronic Control Box Specification: K:\PRODUCT\Product Dev
Projects\1995\95—52 Figure 8 Trailer\Electronic Controls\Electronic
functions.lwp
• Machine Electronic Control Box Specification: K:\PRODUCT\Product Dev
Projects\1995\95—52 Figure 8 Trailer\Electronic Controls\Machine Control
Panel.lwp
F. ELECTRICAL / ELECTRONIC SPECIFICATIONS
• 12 volt DC electrical system.
• Two12 VDC battery.
• A 20 ampere attenuettor is used to generate enough power for the
electrical system.
• Throttle, free wheel, strobe lights, work light, blower and controller switches
with fuse are place on the control panel.
• Glow plug is offer for diesel engine.
• Hour meter, emergency switch, hydraulic system pressure, fuel gauge choke
and push start button are also place on the control panel.
• Two strobe and four clearance lights are offered to satisfy the DOT
specification.
Controls: throttle, arm disengage, strobe lights, work light, blower and controller
switches with fuses, also the hour meter, emergency stop switch, hydraulic system
pressure, fuel gauge, choke and push start button.
