176
E
Additional
Information
Time zone, date and time are not set. This message
appears each time you turn the power on until you
set the time zone, date and time ( 51).
Battery pack is exhausted. Replace or charge the
battery pack. ( 158).
Replace the tape or change the position of the
protect switch on the cassette ( 17).
The camcorder stopped operating to protect the
cassette. Remove the cassette and retry the
operation from the beginning ( 163).
DV cable is not connected, or the connected digital
device is turned off ( 90).
Condensation has been detected in the camcorder
( 163).
Tape reached the end. Rewind or remove the tape.
Recording is made in a mode other than the SP
mode. Audio dubbing or AV insert not possible
( 98, 100).
Recording is made in 16-bit or 12-bit 4-channel
mode. Audio dubbing not possible ( 100).
Camcorder detected a blank section on the tape.
Audio dubbing or AV insert not possible
( 98, 100).
Displayed immediately after you start recording
when the video heads are dirty. Clean the video
heads ( 161).
You attempted to playback a copyright protected
tape ( 92).
SET THE TIME ZONE,
DATE AND TIME
THE TAPE IS SET FOR
ERASURE PREVENTION
The camcorder displays various caution phrases for approx. 4 seconds.
Caution Phrases
CONDENSATION
HAS BEEN DETECTED
TAPE END
CHECK THE CASSETTE
[
REC MODE
]
CHECK THE CASSETTE
[
AUDIO MODE
]
CHECK THE CASSETTE
[
BLANK
]
HEADS DIRTY,
USE CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
