15
Getting Started
LED indicator Operation
3. After charging is complete, disconnect the USB cable from the camera and
then from the computer.
NOTE
• Even if you turn on the camera, the battery will continue to charge if there is a USB
connection with a computer. In this case, however, LED indicator operation will
change as described below.
LED indicator Operation
IMPORTANT!
• Charging is not possible if the computer is in a rest or standby state.
• A charging error can occur immediately after charging begins or some time after
charging begins. A charging error is indicated by the LED indicator flashing green
at high speed.
• Leaving the camera for about 14 hours with no power supplied while the battery is
dead will cause its date and time settings to be cleared. A message telling you to
configure time and date settings will appear the next time you turn on the camera
after restoring power. When this happens, configure date and time settings (page
63).
Indicator Status Description
Flashing green Charging
Flashing green, fast Charging problem (page 78)
Off Charging complete
Indicator Status Description
Flashing green Charging
Flashing green, fast Charging problem (page 78)
Lit green Charging complete
LED indicator
