7-5
Cisco PIX Security Appliance Hardware Installation Guide
78-15170-03
Chapter 7 PIX 535
Installing the PIX 535
Table 7-3 lists the relative throughput of the Gigabit Ethernet combinations.
Installing the PIX 535
This section includes the following topics:
• Before Installing the PIX 535, page 7-5
• Mounting the PIX 535, page 7-5
• PIX 535 Network Interface Installation, page 7-6
Before Installing the PIX 535
Observe the following before installing the PIX security appliance:
• Review the safety precautions outlined in the Regulatory Compliance and Safety Information
document.
• Place the PIX security appliance on a stable work surface.
Mounting the PIX 535
To mount the PIX 535 on a rack, perform the following steps:
Step 1 Attach the mounting brackets to the unit using the supplied screws.
Step 2 Attach the brackets to the holes near the front on both sides of the unit.
Step 3 Attach the unit to the equipment rack.
Table 7-3 Relative Throughput of Gigabit Ethernet Combinations
Gigabit Ethernet Card Bus Type
Shared with
33 MHz Device Speed
PIX-1GE-66 64/66 No 100%
PIX-1GE-66 64/66 Yes 50%
PIX-1GE-66 32/33 No 25%
PIX-1GE 64/66 No 50%
PIX-1GE 32/33 No 25%
