MONO
Please read through the previous Stereo section for general notes on securing good connections, and
safety tips. If the unit has been previously used in stereo, make sure it is OFF, and remove all
connections, including the AC line cable. Make sure the STEREO/MONO switch is switched to the
MONO position [DOWN].
The MONO "Input" is the "left channel input", as marked. The unused right channel input is
automatically disconnected. MONO output connections are marked below the connectors.
Repeat the above MONO settings and connections on the second CA-150 to be used for the other
channel.
Please remember that the negative output connection of a bridged amplifier is NOT a ground. Do not
use a "common ground" or switchbox set-up. Do not use with electronic crossovers which have a
common ground.
REMOTE CONTROL: (OPTIONAL)
With a simple connection from the receiver box to the remote jack at the back of the amplifier,
(see Figure 1) the power amplifier can be turned ON/OFF from a distance (or from another room).
