36
English
VibrAlert
®
Mode
In VibrAlert
®
mode, your radio can alert you to incoming
signals by sounding an audible call tone, a silent vibration or
both.
To set VibrAlert
®
:
1. The display will show either the Vibrate icon (shake
bars), Call Tone icon (bell shape) or a combination
VibrAlert
®
icon.
2. The present setting of either, 01, 02 or 03 will be
flashing.
3. Press Channel Up/Down button to select one of the
following:
01 = VibrAlert
®
On (both shake bars and bell
shape).
02 = Vibrate On (shake bars only).
03 = Call Tone Only On (bell shape only).
4. Press Call/Enter/Setup button to save this entry and
move to the next setup programming mode.
Call Tone Mode
In Call Tone mode, your radio can alert you to incoming
signals by sounding an audible call tone, a silent vibration or
both. This setting will also allow you to transmit a unique
Call Tone alert to identify your radio when you transmit
messages. You can select from one of 10 different Call Tone
signals.
To Set Call Tone:
1. From the previous press of the Call/Enter/Setup
button, the LCD will display the letter “C” and the
current Call Tone number (01 through 10).
2. Press the Channel Up/Down button to select a
different Call Tone. An example of each call tone will
sound for 1.5 seconds.
3. Press Call/Enter/Setup button to save this entry and
move to the next setup programming mode.
NOTE
Call Tones are not usually used for Marine VHF
communications. We allow you to turn it On for your
unique communication needs.
Setup Mode Programming
Operating Your Radio
VibrAlert
®
Tone Alert
Call Tone Mode
MRHH325EU-Body.qxp:400_Body 12/15/06 8:21 AM Page 36
