A SERVICE OF

logo

Open as PDF
next previous
Booting and Installing an Operating System 6-23
Example 6–6 shows a boot from a local disk. The example is abbreviated. For
complete instructions on booting OpenVMS, see the OpenVMS installation
document.
1. Power up the system. The system stops at the SRM console prompt,
P00>>>.
2. Set boot environment variables, if desired. See Section 6.2.
3. Install the boot medium. For a network boot, see Section 6.2.4.
4. Enter the show device command ➊ to determine the unit number of the
drive for your device.
5. Enter the boot command and command-line parameters (if you have not set
the associated environment variables.). In Example 6–6, the boot command
with the -flags option
➋ causes the system to boot from [SYS0.EXE] on
device DKA0.