Problem Cause Remedy
Engine fails to start Fuel tank empty, or stale fuel
Throttle control lever not in correct starting
position (if equipped)
Blocked fuel line
Dirty air cleaner
Choke not in ON position
Spark plug wire disconnected
Faulty spark plug
Engine flooded
1.
2.
3.
4.
5.
6.
7.
8.
Fill tank with clean, fresh gasoline
Move throttle lever to start position
Clean fuel line
Refer to the Engine Operator’s Manual
Move switch to ON position
Connect wire to spark plug
Clean, adjust gap or replace
Refer to the Engine Operator’s Manual
1.
2.
3.
4.
5.
6.
7.
8.
Engine runs erratic Tiller running on CHOKE
Spark plug wire loose
Blocked fuel line or stale fuel
Vent in gas cap plugged
Water or dirt in fuel system
Dirty air cleaner
Carburetor out of adjustment
1.
2.
3.
4.
5.
6.
7.
Move choke lever to OFF position
Connect and tighten spark plug wire
Clean fuel line; fill tank with clean, fresh
gasoline
Clear vent
Drain fuel tank, refill with fresh fuel
Refer to the Engine Operator’s Manual
Refer to the Engine Operator’s Manual
1.
2.
3.
4.
5.
6.
7.
Engine overheats Engine oil level low
Dirty air cleaner
Air flow restricted
Carburetor not adjusted properly
1.
2.
3.
4.
Fill crankcase with proper oil
Refer to the Engine Operator’s Manual
Refer to the Engine Operator’s Manual
Adjust carburetor as instructed in separate
engine manual.
1.
2.
3.
4.
Tines do not engage Foreign object lodged in tines
Tine clevis pin(s) missing
Pulley and idler not in correct adjustment
Not shifting properly
Control cable not adjusted properly
Belt worn and/or stretched
1.
2.
3.
4.
5.
6.
Dislodge foreign object
Replace tine clevis pin(s)
Take tiller to authorized service dealer
Refer to the Controls & Features Section for
proper shifting procedures
Adjust control cable
Replace belt
1.
2.
3.
4.
5.
6.
Tines skip over ground Improper rotation.1. Forward rotation should only be used on soil
that has already been tilled, not on virgin soil.
1.
Wheels do not engage Clevis pin missing
Tiller is not being shifted properly
Control cable not adjusted properly
Belt worn and/or stretched
1.
2.
3.
4.
Replace clevis pin
Refer to Controls & Features Section for
proper shifting procedures
Adjust control cable
Replace belt
1.
2.
3.
4.
Troubleshooting
8
18
