A SERVICE OF

logo

l. hard drive
m. MEMS board
n. USH board
o. GPS module
p. docking board
q. bottom cover
r. battery
4. Follow the procedures in After Working Inside Your computer.
Removing the Power Connector
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. battery
b. bottom cover
c. docking board
d. GPS module
e. USH board
f. MEMS board
g. hard drive
h. Disconnect the battery cable from the battery board.
i. system fan
j. card bracket
k. memory module
l. antenna routing bracket
m. WLAN
n. WWAN
o. heatsink
p. battery board
q. SIM board
r. system board
3. Pull the power connector from slot to release the power connector from the computer chassis.
33