A SERVICE OF

logo

Installing the Input/Output (I/O) Board
1. Place the Input/Output (I/O) board in the computer.
2. Tighten the screw to secure the Input/Output (I/O) board to the computer.
3. Install:
a) system board
b) left support frame
c) right support frame
d) display assembly
e) ExpressCard reader cage
f) palmrest
g) thermal module
h) right base panel
i) WLAN card
j) hard drive
k) optical drive
l) keyboard
m) keyboard trim
n) access panel
o) battery
p) ExpressCard
q) SD memory card
4. Follow the procedures in
After Working Inside Your Computer
.
Removing the Power Connector
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) SD memory card
b) ExpressCard
c) battery
d) access panel
e) keyboard trim
f) keyboard
g) optical drive
h) hard drive
i) WLAN card
j) right base panel
k) thermal module
l) palmrest
m) ExpressCard reader cage
n) display assembly
o) left support bracket
p) system board
3. Remove the power connector cable from the routing channels.
42