41
ENGLISH
[1] 2-channel mode settings
In the auto decode mode, it is possible to automatically conduct multi-channel playback in the Dolby Digital or DTS surround mode or play in
the stereo 2-channel mode (AUTO STEREO mode: factory default setting). For 2-channel input signals, one of four play modes can be set
with the 2-channel mode setting (Auto Stereo, Dolby Pro-Logic II Cinema, Dolby Pro-Logic II Music and Dolby Pro-Logic).
When the function is set to VCR, CDR/TAPE or TUNER, the “Auto Stereo” 2-channel mode cannot be selected. To play in stereo,
set the surround mode to “STEREO” (page 35).
VOLUME
ENTER
BAND
MODE
MENU
FUNCTION
DISPLAY RETURN INPUT MODESURROUND
TOP MENU
SETUP
SDB/TONE
MUTE
SURR.PARA
SUB TITLE ANGLE
AUDIO
SHIFT
CH.SELECT
CH
T.TONE
TU
PROG/DIRECT
REPEAT A-B
REPEAT RANDOM
DVD
TV/VCR
SLEEP
REMOCON MODE
CALL
0
+10
STATUS
CDR/MD/TAPE
TUNER/TV/VCR
VCR POWER
TV POWERTV POWER
NTSC/PAL
MEMO
POWER
CH
2
1
3
3
1
Set the surround mode to “AUTO DECODE”.
•“AUTO DECODE” is displayed, then the normal display
reappears.
Remote control unit
2
Press the SURR.PARA button on the remote control unit and
select the 2-channel decode mode.
Remote control unit
This can be selected when the digital input consists of no
signal, PCM signals, Dolby Digital 2-channel signals, as
well as when the analog input is selected.
3
Select the desired 2-channel
decode mode using the ( and
) cursor buttons on
the remote control unit.
• The mode switches as follows
each time one of the buttons is
pressed:
Remote control unit
If the AUTO DECODE/2CH MODE button on the main unit
is pressed when the mode is already set to AUTO
DECODE, the mode switches to the 2-channel mode. The
mode switches as follows each time the button is
pressed.
AUTO ST
PRO LOGIC
PLII CINEMA
PL
II MUSIC
NOTES:
• The 2-channel decode mode cannot be set when Dolby Digital
5.1-channel signals or DTS signals are being input.
• The 2-channel mode setting is stored in the memory individually
for the DVD, TV/DBS and V.AUX modes.
If the mode is set to anything other than AUTO DECODE,
the AUTO DECODE mode can be set using the AUTO
DECODE/2CH MODE button on the main unit.
The Auto Stereo mode can be selected when the function
is set to DVD, TV/DBS or V.AUX.
AUTO STEREO
PRO LOGIC
PLO LOGICII C
PLO LOGIC
II M
Once the surround parameters have been set, stop operating
buttons. After several seconds the display returns to normal and
the settings are automatically validated.
