b If the access points are not detected automatically, use the i
button to select the “Manual” and press the ENTER button.
Setting becomes manual. For details, see “Manual settings”
(vpage 37, 38).
b If the access points are repeat search, use the i button to select
the “Search” and press the ENTER button.
e If there is an encryption setting for the access point you selected
in step w, enter same encryption key as used for the access
point. (If there is no encryption setting, proceed to step t.)
1
Fitting a rod antenna (vpage 22).
b If a LAN cable is connected, remove it.
2
Turn on the AVR-5308CI (vpage 56).
3
Set the access point at the GUI menu “Manual Setup”
– “Network Setup” – “Network Setup”.
When searching access points to connect automatically, refer to
“Automatic settings”.
When searching access points to connect manually, refer to
“Manual settings”.
n Automatic settings
q Select “Search” and press the ENTER button.
The access point you have set is displayed.
w
Use the ui button to select the access point, and then press
the ENTER button.
e Use the ui p button to input the address and press the ENTER
button.
IP Address
:
Set the IP address within the ranges shown below. The Network
Audio function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask
:
When connecting an xDSL modem or terminal adapter directly
to the AVR-5308CI, input the subnet mask indicated in the
documentation supplied by your provider. Normally input
255.255.255.0.
Default Gateway
:
When connected to a gateway (router), input its IP address.
Primary DNS
Secondary DNS
:
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at “Primary DNS”. If there are
two or more DNS addresses, input the first one at “Secondary
DNS”.
r
Use the i button to select “Exit” and press the ENTER button.
Setup is complete.
b When connecting to the network via a Proxy server, select “Proxy”
and press the ENTER button (vpage 38 “Proxy settings”).
Select when searching
access points again.
Wireless LAN settings
Use this procedure to configure the Wireless LAN settings.
w Select the access point.
Example) DENON
Select when access
points cannot be searched
automatically.
q Select “Search”.
r Set only during
“WEP” in step w.
t Select “Connection”.
e Enter
encryption key.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
