ENGLISH
35
Advanced Operation
ENGLISH
Advanced Operation
Multi zone music entertainment system
• ZONE2 speaker out can be used when “ZONE2” is selected at “Power Amp Assignment”. In this case, surround back speaker out
cannot be used for MAIN ZONE.
• When a sold separately room-to-room remote control unit (DENON RC-616, 617 or 618) is wired and connected between the MAIN
ZONE and ZONE2, the remote-controllable devices in the MAIN ZONE can be controlled from ZONE2 using the remote control unit.
• For instructions on installation and operation of separately sold devices, refer to the devices’ operating instructions.
2 When using the SURR.BACK/ZONE2 amplifier as the ZONE2
• To use the ZONE2, turn on the ZONE2 button.
• The output of the ZONE2 SPEAKER OUT terminals can be adjusted with the remote control unit’s ZONE2 VOLUME button.
• The input source selected with the INPUT SELECTOR knob is output for the ZONE2 speaker output.
[System configuration and connections example]
Using this unit’s internal amplifier as the ZONE2.
: SPEAKER cable
: ROOM-TO-ROOM REMOTE CONTROL SYSTEM (separately sold) control line
Refer to “Connections” ( page 11).
Remote control unit operations during
multi-source playback (selecting the source)
1
Set the MODE 1 switch to the “AUDIO”.
2
Set the MODE 2 switch to the “ZONE2”.
3
Press the ZONE2 ON button.
To cancel the ZONE2 mode:
Press the ZONE2 OFF button.
4
The output level of the ZONE2 SPEAKER OUT
terminals can be controlled pressing the
VOLUME button on the remote control unit.
Default setting (ZONE2 VOLUME LEVEL):
– – – dB (MINIMUM)
This is only possible when the main unit in the ZONE2 mode
( page 16).
