A SERVICE OF

logo

Open as PDF
next previous
ENGLISH
1
Select the items.
The measurement results of each item can be checked here.
A.Set SpConf.Ck
(Remote control unit)
2
Press the ENTER button and display the verification screen.
(Remote control unit)
NOTE:
• When measurements have been made using the measurement microphone, speakers with a built-in
filter such as subwoofers might be set with a value that differs from the physical distance because of
the internal electrical delay.
[Speaker Config. Check] [Delay Time Check] [Channel Level Check]
3
If the check ends, press the ENTER button again.
(Remote control unit)
4
Select from the following three items based on the measurement
results.
• Store : Set with the checked measurement value.
• Retry : Perform the measurement again.
• Cancel : Cancel the checked measurement value.
A.Set <Store
(Remote control unit)
5
When the “Store” is selected, all parameters are stored up and
switch to the SUBWOOFER MODE setting.
(Remote control unit)
24
Check of the measurement results