5
Select the speaker to be set.
The picture of the speaker selected blinks.
6
Set the distance between the center speaker and listening position.
The distance changes in units of 0.03 meters (0.1 foot) each time the button is
pressed. Select the value closest to the measured distance.
Example: When the distance is
set to 3.6 m for the
center speaker
If “Yes” is selected for “Default”, the settings are automatically reset
to the default values.
Please note that the difference of distance for every speaker should be 6.0
m (20 ft) or less. If you set an invalid distance, a CAUTION notice, such as
screen right will appear. In this case, please relocate the blinking speaker(s)
so that its distance is no larger than the value shown in highlighted line.
7
Enter the setting.
The Speaker Setup Menu reappears.
The AVR-2805 automatically sets the optimum surround delay time for the listening
room.
NOTE:
• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values
(see page 11).
• Input the distance between the listening position and each speakers to set the delay time for the surround
playback.
2-2 Setting the Delay Time
Preparations:
Measure the distances between the listening position and the speakers
(L1 to L5 on the diagram at the right).
L1: Distance between center speaker and listening position
L2: Distance between front speakers and listening position
L3: Distance between surround speakers and listening position
L4: Distance between surround back speakers and listening position
L5: Distance between subwoofer and listening position
