ENGLISH
27
5
• DEFAULT setting
DEFAULT Y
/N
YES
NO
,/
When “YES” is selected, the settings are reset to
their factory default values.
NOTE:
• When playing PCM digital signals or analog signals in the
5CH STEREO, ROCK ARENA, JAZZ CLUB, VIDEO
GAME, MONO MOVIE or MATRIX surround modes and
the input signal switches to a digital signal encoded in
Dolby Digital, the Dolby surround mode switches
automatically. When the input signal switches to a DTS
signal, the mode automatically switches to DTS
surround.
Surround parameters (3)
ROOM SIZE:
• This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-
small), “medium”, “med.l” (medium-large) and
“large”. “small” recreates a small sound field, “large”
a large sound field.
EFFECT LEVEL:
• This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. When
the surround mode is set to “VIRTUAL”, the effect
level can be set in steps from 1 to 10. Lower the level
if the sound seems distorted.
DELAY TIME:
• In the matrix mode only, the delay time can be set
within the range of 0 to 110 ms.
Y
/
N
Stop operating buttons once the surround parameter
settings have been completed. After several seconds the
normal display reappears and the settings are
automatically set.
(2) DSP Surround simulation
3
Play a program source.
• Refer to instruction manual for handling.
4
To enter the surround parameter
setting mode, press the
SURROUND mode.
• The surround parameter
switches in the following order
each time the SURROUND
button is pressed for the
different surround modes.
There is no 5-channel stereo mode.
Refer to page 28 for the parameters of the “AUTO
DECODE” mode.
5
Display the parameter you want to adjust,
• Use the cursor buttons ( , ) to select the
surround parameter.
Remote control unit
• ROOM SIZE setting
R.SIZE MED
MED-S MED MED-L LARGESMALL
,/
,/
,/
• EFFECT LEVEL setting
EFFECT 10
1 10 15
• DELAY TIME setting
DELAY
30ms
0ms 30ms 110ms
