A SERVICE OF

logo

Open as PDF
next previous
69
System Setup
Audio Setup
Default settings are underlined.
Make settings for audio playback.
Setting items Setting details
2ch Direct/Stereo
Select the method for
setting the speakers used
in the 2-channel direct and
stereo playback modes.
Setting : Select the method for setting the speakers used in the 2-channel
direct and stereo playback modes.
•Basic : The settings at “Speaker Setup” (vpage65) are applied.
•Custom : Make separate settings for 2-channel. Make the following
settings:
Front:Setthefrontspeakersize.
•Large : Use a large speaker that can adequately play back low
frequencies.
•Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
If “Speaker Config.” – “Subwoofer” (vpage65) is set to “No”,
the setting is automatically set to “Large”.
SW : Set the presence of a subwoofer.
•Yes : Use a subwoofer.
•No : Select when a subwoofer is not connected.
If “Speaker Config.” – “Subwoofer” (vpage65) is set to “No”,
the setting is automatically set to “No”. If the “Front” setting is
“Small”, the setting is automatically “Yes”.
SW Mode : Select low range signals to be reproduced by subwoofer.
•LFE:Whenthe“2chDirect/Stereo”–“Front”settingissetto“Large”,
the LFE signal alone is output from the subwoofer. Also, when the “2ch
Direct/Stereo”–“Front”settingissetto“Small”,thefrontchannellow
range signal is added to the LFE signal output from the subwoofer.
•LFE+Main : The front channel low range signal is added to the LFE signal
output from the subwoofer.
Thissettingcanbesetmade“2chDirect/Stereo”–“SW”issetto
“Yes”.
Crossover : Set the maximum frequency of the bass signal output from
each channel to the subwoofer.
•40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz
•This setting canbe set made “2ch Direct/Stereo”– “SW” is set to
“Yes”.
•Ifthe“2ch Direct/Stereo”–“Front” settingis“Large” andthe“SW
Mode” setting is “LFE”, “Full Band” is displayed and the setting cannot
be made.
Setting items Setting details
2ch Direct/Stereo
(Continued)
Distance FL/Distance FR : Select the speaker.
•0.0ft – 60.0ft (12.0ft)/0.00m – 18.00m (3.6m) : Set the distance to the
speaker.
Set the difference in the distance between the speakers to less than
20.0 ft (6.00 m).
Level FL / Level FR : Select the speaker.
•–12.0dB – +12.0dB (0.0dB) : Adjust the level of each channel.
Auto Surround
Make setting for
memorizingsurroundmode
setting for each input signal
type.
ON:Memorizesettings.Automaticallyplaywiththelastusedsurround
mode.
OFF : Do not memorize settings. Surround mode does not change
according to input signal.
•The auto surround mode function lets you store in the memory the
surround mode last used for playing the four types of input signals listed
below.
q Analog and PCM 2-channel signals
w Dolby Digital and DTS 2-channel signals
e Dolby Digital and DTS multi-channel signals
r LPCM Multi-channel signals
•When playing in PURE DIRECT, the surround mode does not change
even if the input signal is changed.
Basic version
Advanced version
Information
Advanced version
BD