SPECIFICATIONS
Models ZTR 4421 & 4422
Hand welded 11 gauge structural tubing.
All body parts are made of rotational molded, high density polyethylene. Fron t
body contains access panel for battery service. Seat lifts forward or backward for
a variety of service points in the transmission area.
13 GA stamped steel construction.
(3) blades combine for a 42" cut width.
Cut height approximately 1" to 4" via 8 position lift handle.
Electric clutch.
Each rear wheel is independently driven by chain and sprockets through a friction,
mechanical drive.
13 HP Diamond Series Briggs & Stratton, 4-Cycle, Single Cylinder, Air-
Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve.
14 HP Kohler Command Pro Series, Overhead Valves, Vertical Shaft, 4-
Cycle, Air-Cooled With Cast Iron Cylinder Sleeve.
Electric by key switch operation with safety interlock blade drive.
Front 41 OX 3.50X4 ribbed tread.
Rear 18X9.50X8NHS
Front 16-21 Ibs.
Rear 8-14 Ibs.
Fuel 2.4 gallons total.
Engine Briggs & Stratton - 1.25 quarts oil.
Kohler - 2 quarts oil with filter.
Width 47" outside rear wheel measurement.
Height 39" to top edge of seat.
Length 67" hitch tab to front bumper.
Weight 480 Ibs.
NOTE: Additional information provided in service instructions under
the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
Model 4421:
!
Model 4422:
STARTING SYSTEM:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
