xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
194
show 802.1x auth_configuration
Port Control: ForceAuth/ForceUnauth/Auto − Shows the administrative
control over the port’s authorization status. ForceAuth forces the
Authenticator of the port to become Authorized. ForceUnauth forces the
port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure and
the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant (user)
to send EAP Request/Identity packets.
SuppTimeout − Shows the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request/Identity packets.
ServerTimeout − Shows the length of time to wait for a response from a
RADIUS server.
MaxReq − Shows the maximum number of times to retry sending packets
to the supplicant.
ReAuthPeriod − Shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled/Disabled − Shows whether or not to re-
authenticate.
Parameters
ports <portlist> − Specifies a range of ports. The port list is specified by
listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1,
port 3 and switch 2, port 4 − in numerical order.
all – Denotes all ports on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the 802.1x authentication states (stacking disabled):
DGS-3324SRi:4#show 802.1x auth_configuration ports 1:1
Command: show 802.1x auth_configuration ports 1:1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Protocol : Radius_EAP
Port number : 1:1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
