17
ENGLISH
Replacing the internal clock battery
Installing the battery is required in some cases. (
Event Scheduling in the User's
Manual - Network Guide) A battery is not contained at the time of factory shipment.
Please replace a battery according to the following procedure.
1.
Turn the projector off, and unplug the power cord.
Allow the projector to cool sufciently.
2.
After making sure that the projector has cooled
adequately, slowly turn over the projector, so that
the bottom is facing.
►Always handle the batteries with care and use them only as
directed. Battery may explode if mistreated. Do not recharge, disassemble or
dispose of in re.
And also improper use may result in cracking or leakage, which could result in
re, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specied.
• Make sure the plus and minus terminals are correctly aligned when loading a
battery.
• Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
• Do not short circuit or solder a battery.
• Do not allow a battery in a re or water. Keep batteries in a dark, cool and dry
place.
• If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing a battery.
WARNING
Battery Cover
3.
Turn the battery cover fully in the direction indicated
“OPEN” using a coin or the like, and pick the cover
up to remove it..
4.
.
Pry up the battery using a athead screwdriver or
the like to take it out. While prying it up, put a nger
lightly on the battery since it may pop out of the
holder.
5.
Replace the battery with a new HITACHI MAXELL,
Part No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push
it into the holder until it clicks.
6.
.Replace the battery cover in place, then turn it
in the direction indicated “CLOSE” using such as
coins, to x.
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
