A SERVICE OF

logo

INSTALLATION GUIDE
Installation
Version 2 Power Carriage Installation Guide
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
The power carriage is an electrically powered tire carriage allowing you to easily
adjust for various wheel base distances.
The power carriage motor is preset to be installed with the carriage screwed in
all the way. Do not run the motor prior to installing it on your dyno.
To prevent possible injury, disconnect the battery before performing any dyno
maintenance or installing any optional accessory.
REMOVING THE HAND CRANK
1 Remove the hand crank from the tire carriage.
1a Screw the carriage all the way in.
1b Loosen the set screw on the hand crank and remove the hand crank.
Figure 1: Remove the Hand Crank
hand crank
set screw