11
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
1. Detach the light kit plate from the fan motor/hous-
ing assembly by removing one screw and loosen-
ing the two other screws (located in the keyholes).
Rotate the light kit plate counter- clockwise to dis-
engaging the screws in the two key hole slots
(Figure 18).
1. Detach the light kit plate from the fan motor/hous-
ing assembly by removing one screw and loosen-
ing the two other screws (located in the keyholes).
Rotate the light kit plate counter- clockwise to dis-
engaging the screws in the two key hole slots
(Figure 18).
3. Cut light socket wires using wire cutters. Unscrew
the screws that is securing the socket plates to the
light kit plate. Pull socket wiring though light kit
plate holes to completely disengage the light sock-
ets from light kit plate (Figure 19).
How to Disassemble Your Light Kit for
Cover Plate Assembly Only
Figure 20
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
U.L. Model No.: CF205
