installation electrolux e:line ovens 3332 electrolux e:line ovens installation
warning
Please follow the points below when installing the appliance
Useanauthorisedperson
other relevant statutory regulations:
local authority.
plate is positioned behind the bottom of the oven door.
The circuit diagram is positioned on the top panel of
the appliance.
disconnect functional switch should be provided near
warning
Thisappliancemustbeproperlyearthed.
measurements. (See diagrams)
your oven into the cupboard by fastening through the
2 holes to the front panel.
may result in deterioration of the low temperature
coating by discolouring or bubbling.
wrapped surfaces, use an installation kit available from
for damage caused by installation into low temperature
tolerant cabinets.
operates correctly before handing it over to the
customer.
warning
To avoid any potential hazard, you must follow our
instructionswhenyouinstallyourappliance.Failure
to install the appliance correctly could invalidate any
warrantyorliabilityclaimsandleadtoprosecution.
Cabinet construction for your appliance
For the best integration within a kitchen, install this appliance
FlushFit
16mm
600mm
20mm
panel
Cupboard
door
Oven
100mm
max for
Pyro oven
ProudFit
16mm
600mm
panel
Cupboard
door
Oven
100mm
max for
Pyro oven
Note:
warning
IMPORTANT:TheinllpanelMUSTnotexceed
100mminlengthtoensurea16mmgapis
maintained
Underbenchoven
Your underbench oven looks best when the control panel
be added if the cooktop placed above the benchtop is too
deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
Cut-out dimensions
type of fit A(width) B(height) C(depth)
600 600
A
C
B
561mm
mounting holes
583mm
596mm
DuoovenCut-outdimensions
type of fit A(width) B(height) C(depth)
600 893
DoubleovenCut-outdimensions
type of fit A(width) B(height) C(depth)
600 1086
1078
min. 650mm
561mm
mounting
holes
A
B
C
mounting holes
596mm
456mm
model product dimensions
(hxwxd)mm
electrical connection min.fuse
rating
max.power
rating
max.
current
rating
EOEM61CS
EOEE62CS
EOEE62CK
EOEE63CS
EUEE63CS, EUEE63CK
EDEE63CS
EPEE63CS, EPEE63CK
min. 650mm
A
561mm
mounting
holes
mounting holes
596mm
456mm
B
C
Hard wiring details
1. Remove terminal cover plate from rear panel of appliance.
2. Fit wires through hole in cover plate and make
connections to terminals.
3. Engage wires into plastic clip. Secure plastic clip with
two long silver screws (supplied in separate bag).
4. Replace cover plate onto rear panel.
Not e:
Plastic clips
Plastic clip
securing points
