What to do if…26
What to do if…
Remedying small malfunctions
Before you call the Customer Care Department, please check whether
– you cannot remedy the fault yourself with the help of the following fault ta
ble
or
– whether it is caused by faulty, electrical connections and/or faulty water con
nections.
In these cases the engineer must make you liable for the costs of the Customer
Service intervention even during the warranty period.
In the event of a fault, the light signal at floor level flashes.
If the acoustic signal is activated, warning tones sound if there are faults.
If one of the following fault codes is displayed in the multidisplay during oper
ation:
– Fault codeÅ10 (Problems with water inlet),
– Fault codeÅ20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has started. The
cycle will continue.
With other fault codes (“Å” followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Reset the dishwashing cycle.
If the fault is displayed again, please contact your local Service Force Centre and
inform them of the fault code.
