26
Starting a dishwashing cycle
1.Check that the spray arms can turn freely.
2.Turn the water tap on fully.
3.Press the ON/OFF button.
4.Select the desired cycle.
The programme indicator comes on. The remaining time expected for
the cycle will be shown in the multi-display.
3 During the dishwashing cycle, the remaining time shown in the multi-
display may be adjusted according to the size of the load, degree of
soiling, etc.
5.Close the door. The dishwashing cycle will begin.
A light signal in the form of a dot appears at floor level.
3 If the dishwasher is built in at high level with flush fitting cupboard
doors, the light signal cannot be seen.
The dot shaped light signal is not dangerous. (It is not a laser.) It lights
up while a dishwasher cycle is running and goes out when the cycle
ends.
Interrupting or aborting a dishwashing cycle
Only interrupt a dishwashing cycle that is in progress if it is absolutely
necessary.
Interrupting the dishwashing programme by opening the dishwash-
er door
1 Hot steam may escape when the door is opened. There is a risk of scald-
ing.
1.Open the door carefully. The dishwashing cycle will stop.
2.Close the door. The cycle will continue.
Aborting the dishwashing cycle
1.Press function buttons 2 and 3 and keep them pressed.
The LED indicators of all the programme buttons that can be selected
light up.
2.Release the function buttons. The dishwashing cycle has been can-
celled.
3.If you want to start a new cycle, check whether there is any detergent
in the dispenser.
