Others Menu
Sub Menu Function
SNMP
Set this parameter to On when using
SNMP
g
to monitor the projector.
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.
Trap IP Address 1/Trap IP
Address 2
When SNMP is set to On, you can set up to two IP addresses as SNMP trap notification destinations.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Priority Gateway
For the priority gateway, select either Wired or Wireless.
AMX Device Discovery
When the projector is connected to a network, set this to On to allow the projector to be detected by
AMX Device Discovery
g
. Set this to Off if you are
not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
RoomView
Set this parameter to On only when using Crestron RoomView
®
to monitor and control the projector over a network. Normally, leave this parameter set
to Off. s "About Crestron RoomView® (EB-G5950/G5650W only)" p.119
Changes in projector settings take effect upon restarting.
The following functions cannot be used when it is set to On.
• Web Control
• Message Broadcasting (EasyMP Monitor plugin)
Network Menu (EB-G5950/G5650W)
80
