Submenu Function
Sleep Mode
When set to On, this automatically stops projection when no
image signal is being input and no operations are carried out for a
specified length of time. Also, if no image signal is input for
approximately five minutes, the lamp dims until the power turns
off. When an image signal is input, the projector returns to
normal operating status.
Sleep Mode Tim
er
When Sleep Mode is set to On, you can set the time before the
projector automatically turns off within a range of 1 to 30
minutes.
Lens Cover Timer
When set to On, this turns off the power automatically 30
minutes after the A/V mute slide is closed. Also, if the A/V mute
slide is closed for approximately five minutes, the lamp dims
until the power turns off. When the A/V mute slide is opened, the
projector returns to normal operating status.
A/V Mute Timer
When set to On, this turns off the power automatically 30
minutes after A/V mute is enabled. Also, if A/V mute is enabled,
the lamp dims until the power turns off. When A/V mute is
disabled, the projector returns to normal operating status.
Standby Mode
If you set Communication On, you can perform the following
operations even if the projector is in standby mode.
• Monitoring and controlling the projector over a network.
• Outputting audio and images to external equipment. (Only
when A/V Output is set to Always On.)
• Outputting audio from the projector's speaker. (Only when
A/V Output is set to Always On.)
ECO Display
When set to On, when the lamp brightness changes from normal
to low or low to normal, leaf icons are displayed at the bottom-
left of the projected screen to indicate the power-saving status.
Reset
You can reset all adjustment values on the ECO menu to their
default settings, except for Standby Mode. See the following to
return all menu items to their default settings.
s "Reset Menu" p.119
Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status
of the projector. Items that can be displayed vary depending on the source
currently being projected. Depending on the model used, some input
sources are not supported.
s "Automatically Detect Input Signals and Change the Projected Image
(Source Search)" p.41
List of Functions
118
