Using the Projector Menus
■ ■ ■ ■
50
Video Menu (Image source = Video)
The Video menu enables you make adjustments to the
projected image. The following options are available when the
image source is Video.
♦
Note:
The video source (such as a VCR or camcorder) must be
connected and operating, and the image source on the projector
must be set to Video for you to access these menu options.
Menu item Description
Brightness Lightens or darkens the overall image. Increase
brightness to make the image lighter, or decrease it to
make the image darker.
Contrast Adjusts the relative difference between light and dark
areas. Increase contrast to make light areas lighter
and dark areas darker, or decrease it to lessen the
difference between the light areas and dark areas of
the image.
Sharpness Adjusts screen sharpness.
Increase sharpness to make screen images more
sharp, or decrease it to make the images less sharp.
Saturation Adjusts color density. Increase color density to make
colors darker and more opaque, or decrease it to make
colors lighter and less opaque.
Tint (NTSC only) Adjust the red-green balance of the screen. Increase
tint to add more green, or decrease it to add more red.
Auto Specifies the video signal system. Normally this signal
system setting should be left at AUTO for automatic
detection of the video signal system. If automatic
selection is not possible for some reason, use this
menu to manually specify NTSC, NTSC 4.43, PAL,
MPAL, NPAL, PAL (60Hz) or SECAM.
