61
Appendices
Rear
Base
•
••
•
Control (RS-232C) port
Connects the projector to a computer using an
RS-232C cable. This port is for service use,
and should not normally be used.
•
••
•
USB port (
Setup Guide
)
Connects the projector to a computer
using a USB cable.
•
••
•
Remote control
light-receiving area
(
Setup Guide
)
Receives signals from
the remote control.
•
••
•
Rear adjustable foot
(p.12)
Extend and retract to adjust
the horizontal projection
angle.
•
••
•
S-Video port
(
Setup Guide
)
Inputs an S-Video
signal to the projector from
other video sources.
•
••
•
Audio 2 port (
Setup Guide
)
Inputs audio signals.
•
••
•
Audio 1 port
(
Setup Guide
)
Inputs audio signals.
Connects using a stereo
mini jack.
•
••
•
Computer 1 port (
Setup Guide
)
Inputs digital/analog RGB image
signals from a computer.
•
••
•
Computer 2/ Component Video port
(
Setup Guide
)
Inputs component video images from a video
source or analog video signals from a computer.
•
••
•
Monitor Out port (
Setup Guide
)
Outputs the projected analog image signal from a
computer to an external monitor.
This is not available for digital image signals being
input to the Computer 1 port or signals from other
video sources.
Remove the cover when using this port.
•
••
•
Video port (
Setup Guide
)
Inputs composite video signals to
the projector from other video
sources.
•
••
•
Speaker
•
••
•
Power inlet (p.6)
Connects the power cord.
•
••
•
Remote port
Connects an optional
remote control receiver to
the projector.
•
••
•
Suspension
bracket fixing points
(4 points)
(p.53,
Setup Guide
)
Install the optional ceiling
mount here when suspending
the projector from the ceiling.
•
••
•
Air filter (air inlet)
(p.46, 50)
Prevents dust and other
foreign particles from
being drawn into the
projector.
When replacing the lamp,
replace the air filter also.
•
••
•
Rear adjustable foot
•
••
•
Front adjustable foot
Front/ Top Rear Remote control
Control panel Base
