25
Viewing Images at a Preset Image Quality(Memory Function)
Image Quality Adjustments
TIP
Adjust each of the settings to the values
to be saved.
Press , and select "Save
Memory".
The Save Memory screen is displayed.
Select the memory name to register the
adjustments to from Memory1 to 10, and
press or .
When preceding the memory name is
green, this indicates that adjustments are
already saved to memory.
Select an already saved memory name, and
press or .
A confirmation message will be displayed.
If you select "Yes", the previous memory
content is erased, and the current adjustment
values are saved.
The colour mode selected
when the memory was
registered is displayed on the
right side.
Memory settings that have
been applied to images will be
retained even when the
projector's power is turned off.
The same memory adjustment
settings will be applied to
images that are projected the
next time the projector's power
is turned on.
The aspect setting retrieved
from memory may not be
applied to the images if they
are 16:9 images or if the input
signal images have a particular
resolution.
Save Memory
Load saved memories.
Load Memory
This feature can be used to erase and clean up
unwanted memories.
Press , and select "Erase Memory".
The Erase Memory screen will be displayed.
Select the memory name to erase.
A confirmation message will be displayed. If
you select "Yes", the memory will be erased.
To erase all saved memories, select "Reset" -
"Reset Memory" in the Configuration menu.
p.35
Erase Memory
Press , and select "Load Memory".
The Load Memory screen will be displayed.
Select the target memory name.
