8
Part Names and Functions
Rear
Base
• [SCART] input port p.12
Connects to the SCART ports of
other video equipment using the
D4 SCART adaptor that is
packed with the projector.
• [Trigger out] port
When the projector power
is turned on, a 12 V DC
signal is output from this port.
When the projector's power is
turned off or a problem with
operation occurs, the output
becomes 0 V to send the
projector's power ON/OFF
status to an external device.
• [Video] input port p.12
Connects to general video ports of
other video equipment.
• [HDMI ] input port p.12
Connects to video equipment or a
computer that is HDMI-
compatible.
• [S-Video] input port p.12
Inputs an S-Video
signal to the
projector from other video equipment.
• [RS-232C] port
Connects the projector to a computer
using an RS-232C cable. This port is
for control use and should not be used
by the customer.
• Power inlet p.14
Connects the power cable.
• Main power switch
p.14
• Security lock
p.53
• Remote control
light-receiving
area p.13
Receives signals
from the remote
control.
• [InputB] port p.12
Connects to the RGB
port of a computer.
• [InputA] port p.12
Connects to the component video
(YCbCr or YPbPr ) ports
of other video equipment.
• Suspension bracket fixing points (4 points) p.46
Install the optional ceiling mount here when suspending the projector from a ceiling.
• Air filter (air intake vent)
p.42, 44
Prevents dust and other foreign particles
from being drawn into the projector.
It should be cleaned periodically.
• Lamp cover p.44
Open this cover when replacing the lamp
inside.
