Using the Paper Memory Feature
Saving information for
overlappb
multi-part forms-with labels
To save paper format and thickness information for multi-part
forms ‘that overlap slightly and have ‘labels on
them, follow the
steps below.
1.
2.
3.
4.
5.
Load the overlapping multi-part forms with labels onto the front
tractor. (See the section on
lqqdingpaper onto the front tractor
in Chapter
2.)
Turn off the printer.
Use DIP switch
3-4
to select the memory area where you want
the printer to store the paper format and thickness information.
Memory area 1 is selected when DIP switch
3-4 is off. (This is
the printer’s default setting.) To select memory area
2,
turn on
the switch.
Use DIP switch
3-2
to set the page length. The page length is 11
inches when DIP switch 3-2 is off and 12 inches when the switch
is on. If you plan to use forms of a different page length, use
software commands to set the page length after you finish
saving the form’s information.
Turn on DIP switches
3-5 and
3-6.
This tells the printer you
want to save information for multi-part forms that overlap
slightly and have labels on them.
Note: Whenever DIP switch
3-5 is on, the skip over perforation
feature is valid, regardless of DIP switch
3-3’s
setting.
6..
Follow steps 6 through 14 on pages 3-25 through
3-29.
3-30
Using the Printer
