EPSON PowerLite 5350/7250/7350 Projector
8/99 EPSON
PowerLite 5350/7250/7350 Projector - 5
Using the Remote Control
The remote control uses a line-of-sight infrared signal. To use
the remote control, point it towards one of the infrared
receivers located at the front and back of the projector. You
can use the remote control up to about 32.8 feet (10 meters)
from the projector. (This distance may be shorter if the remote
control batteries are low.) You must also be within a
± 30°
angle from the front or rear receiver.
Note: The projector may not respond to remote control commands
in these conditions: ambient light is too bright; a certain type of
fluorescent light is present; a strong light source (such as direct
sunlight) shines into the infrared receiver; or other equipment
emitting infrared energy is present (such as a radiant room
heater). Correct these conditions to use the remote control or
control the projector from a computer.
Open the cover just below the
Esc button to access additional
remote control commands.
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
Enter (pointer)
button
Esc button
Freeze
A/V Mute
E-Zoom
Special effects
buttons (1-5)
illumination
IR output
Power
remote control
On/Off
battery cover
cover lock
Front
Back
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
Menu
Comp1
S-Video
Auto
P in P Preset
Resize
Video
BNC
Help
- Volume +
Menu
Comp1
S-Video
Auto
P in P
Volume
Help
BNC
Video
Resize
Preset
