21
Setting Up the Printer On a Network | 21
12. Press or to change each octet value, then press Menu to select
the next octet. When you have changed the value of the last octet, press
Menu then . The LCD displays GW. Press Menu again to
display the default gateway.
13. Press or to change each octet value, then press
Menu to select
the next octet. When you have changed the value of the last octet, press
Menu , then press the pause button to exit the printer menu.
14. Turn the printer off then back on again.
15. Make sure that the printer displays
READY and that you have at least
three sheets of plain, letter-size paper loaded in the printer’s auto sheet
feeder. Then press the
Menu button to enter the printer menu.
16. Press to highlight
TEST PRINT, then press Menu .
17. Press to highlight
NETWORK, then press Menu .
18. Press
Menu to print the network status sheet and verify that the IP
address settings are correct. Then see “Installing the Software for
Macintosh” below, or “Installing the Software for Windows” on
page 24.
Installing the Software for Macintosh
Follow the steps below to install the software on a Macintosh. For Windows,
see page 24.
1. Turn on your Macintosh and your printer.
2. Insert the printer software CD-ROM. If necessary, double-click the
Epson CD-ROM to open its window.
3. Double-click the
Epson installer icon.
Note: You can check for
newer versions of your
printer driver and utilities
on the Epson support site
at epson.com/support.
