When you are finished, press 0 and Enter to display the modified DEVICE
LIST for a final check. If the list is correct, press Y and Enter. You are now
ready to select a test.
Selecting a Test
From the DEVICE
LIST,
select the device to be tested. Type the number of
the device, and then press
Enter.
The following menu appears:
Number of times to test device
l-
Run test one time
2
-
Run test multiple times
O-
Exit
Enter selection number:
You can specify that the test be performed one time only or any number of
times up to 9999. Running a test multiple times is for reliability testing of
essential functions only; in most cases running a test only once is sufficient.
To perform the test only once, press
1
then
Enter.
Depending on the device
you have selected, the program may then display a submenu of more
detailed tests you can select.
To perform the test multiple times, press 2 and
Enter.
You see this prompt:
Terminate checking if an error is detected (Y/N)?
Press Y and
Enter
to terminate checking if the device produces an error, or
press
N
and
Enter
to repeat the tests regardless of an error. This prompt
then appears:
How many times
(1-9999)?
Type the number of times you want to repeat the test; then press Enter.
The tests for the device now start.
Performing System Diagnostics
D-3
