Check the pre-motor fi lter each time the dust bag is changed.
Clean or replace as needed.
To Clean Pre-Motor Filter
1. Remove fi lter screen and fi lter centered in the bottom of
2. Shake fi lter to remove excess dust. If necessary, the fi lter
can be cleaned by vacuuming with another cleaner or
washing with mild detergent.
3. Reinstall fi lter after completely dry, and replace fi lter screen.
Use GENUINE EUREKA replacement pre-motor fi lter,
Only cartridge style fi lters can be used
Check the True HEPA fi lter each time dust bag is changed.
Replace twice a year or as needed.
1. Push down on fi lter door latch and pull door away from
2. Push down on HEPA cartridge latch and remove fi lter.
1. Place bottom tabs of fi lter cartridge into slots. Rotate
fi lter toward cleaner, press fi rmly against cleaner to latch.
Make sure True HEPA cartridge latch is secured on
2. Replace fi lter door by placing tabs of door into slots on
cleaner. Rotate door up and against cleaner until it locks
NOTE: To have the benefi t of a sealed True HEPA
system, you must use one of the True HEPA
cartridge fi lter systems.
Use GENUINE EUREKA replacement True HEPA fi lter,
(Only for models with a headlight)
NOTE: Turn off the power switch and disconnect
the electrical cord before changing light
1. Lower handle. Remove the screw from lens cover.
2. Pull lens cover from cleaner.
3. Pull old light bulb out of socket.
4. Push new light bulb into socket.
4. Push new light bulb into socket.
Use GENUINE EUREKA replacement light bulb,
2. To remove debris, tap fi lter against waste container or
brush off. You may also vacuum the fi lter using a different
cleaner, if fi lter needs further cleaning, wash under warm
When all parts are completely dry
steps in reverse to reassemble.
NOTE: Do not put any parts in a dishwasher.
NOTE: Your washable filter may need to be
replaced if cleaning it does not restore
Be sure to use GENUINE EUREKA replacement fi lters.
