6
Unpacking and Set-Up
Unpacking:
The BIG SKY P-Series Platter is shipped in two boxes. The mast is contained in
the rectangular box, and the three decks are packed in the square box. Unpack
the mast box, and check for the main mast assembly, horizontal crossbar, and
accessories (p-o heads, rings, etc.). Make sure all parts are present and
undamaged. Inspect the deck box for any damage before opening, then open
and inspect the contents for any damage. If there is any damage, be sure to
contact the carrier or your dealer.
Assembly:
Only two operations need to be done:
First, attach the bottom crossbar to the bottom horizontal leg, with the feet
towards the floor. Leveling the platter is recommended in case of an uneven
floor, to avoid erratic platter operation and film shift.
Second, slide each platter deck over and down each spindle until it is seated.
Make sure that the motors are in the disengaged position before lowering the
deck on the spindle.
Power-Up
The power input module is located on the bottom of the mast. Plug the line cord
into a wall outlet. The switch is marked 0" for off and I for on. When the platter
is first turned on, a short beep is heard as the system initializes itself. Check
that all sliders operate their motors, and that the pay-out heads also work. The
platter is now ready for use. If any adjustments are needed, consult the control
plate drawing for adjustment types and locations. No adjustments should be
needed, as each platter is factory tested and calibrated before shipment.
